MIL-S-22824E
(Application for copies should be addressed to ASTM, 1916 Race Street,
Philadelphia, PA 19103-1187.)
AMERICAN WELDING SOCIETY (AWS)
AWS D1.1 - Structural Welding Code, Steel.
(Application for copies should be addressed tO the American Welding
Society, 550 N.W. LeJeune Road, P.O. Box 351040, Miami, FL 33135.)
(Non-Government standards and other publications are normally available from
the organizations that prepare or distribute the documents. These documents
also may be available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of
this document and the references cited herein (except for associated detail
specifications, specification sheets or MS standards), the text of this document
takes precedence. Nothing in this document, however, supersedes applicable laws
and regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 Description. The sling assembly, as referred to in this specification,
and as applicable, consists of upper, lower, and extension wire rope legs,
spreader bars, attachments (shackles, pear links) and safety hooks.
3.2 First article. When specified (see 6.2), the contractor shall furnish
one sling assembly for first article inspection and approval (see 4.2.1 and
6.3).
3.3 Materials. Materials used shall be free from defects which would
adversely affect the performance or maintainability of individual components or
of the overall assembly. Materials not specified herein shall be of the same
quality used for the intended purpose in commercial practice. Unless otherwise
specified herein, all equipment, material, and articles incorporated in the work
covered by this specification are to be new and fabricated using materials
produced from recovered materials to the maximum extent possible without
jeopardizing the intended use. The term "recovered materialism" means materials
which have been collected or recovered from solid waste and reprocessed to
become a source of raw materials, as opposed to virgin raw materials. Unless
otherwise specified, none of the above shall be interpreted to mean that the use
of used or rebuilt products is allowed under this specification.
3.4 Figures. Figures 1 through 9, forming a part of this specification, are
engineering design sketches. The supplier is responsible for preparing his own
shop drawings. Where tolerances prescribed could cumulatively result in
incorrect fits, the supplier shall provide tolerances within those prescribed on
the sketches to insure correct fit, assembly, and operation of the items. No
deviation from the prescribed dimensions or tolerances is permissible without
prior approval of the contracting officer.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business